Monday, December 20, 2010

Santa's workshop

I was hit by a sudden panic two weeks ago.  So I've been busy.  However, I'm now less stressed.










About the little pile of  zipped leather containers pictured above - some time ago one of my local sewing friends gave out a pattern for an ingenious case for eyeglasses.  Hers was made from fabric but I chose to use leather, most of which came from thrift store leather skirts.

The piece is 21.5" long by 2 5/8" (52 x 6.5 cm) wide, with round ends. Interface the piece with fusible.  Find a zipper of about 24" (60 cm) in length.

Sew the zipper to the leather, starting with the bottom end of the zipper at a point about 2.5" (6cm) from one end and continuing to a similar point at the other end.  Then repeat, going in the opposite direction.  You may have to rip and re-establish the stopping point to ensure that it zips up evenly (you will immediately see what I mean if you make one and it doesn't).  The further away from the end you start, the fatter and shorter the resulting case will be.  I thought 2.5" produced a case with a good length to width ratio.

When sewing the zipper around the round end, you will need to clip into the zipper tape to let it curve.

Then topstitch from the right side.

Next, you have to trim the open ends of your zipper and secure them inside with a couple of hand stitches.


To line, cut the same piece from thin (100 weight) polar fleece or similar fabric.  Remove about .25" (7mm) from the edges.

Coat the wrong side of the leather piece with rubber cement.  Let it dry a bit, then place your fleece piece on top, patting it down so it sticks to the glue.
Attach the lining to the zipper tape with hand stitches.

Start to zip ...

And you're done!

No comments:

Post a Comment